%202-01.png)
Please read before installing your decal / sticker.
You may want to check out our decal / sticker care guide 'here'.
Decal Installation Guide (Dry Method)
* Once the decal has been applied it cannot be repositioned.
* The decal is not reusable once it has been removed.
STEP 1
Clean the surface thoroughly.
Remove any grease, oil or dirt.
STEP 4
Gently lay and apply pressure from one side to another. Then use a credit card or similar hard card to press the sticker down firmly.
STEP 2
Place the sticker in the desired position and put a piece of masking tape to temporary secure it in place.
STEP 5
Slowly peel and remove the transfer paper. Be careful not to pull the sticker off the surface. If sticker still sticks on transfer tape, repeat step 4.
STEP 3
Lift the sticker up and peel off the backing paper, ensuring the decal attaches to the transfer paper, nothing should left behind.
STEP 6
Check for any lifts, gently rub if down with your fingers if any lifting does occurs.
Decal Installation Guide (Wet Method)
* Once the decal has been applied it cannot be repositioned.
* The decal is not reusable once it has been removed.
STEP 1
Prepare a soapy water solution
(5% dish soap, 95% water),
mixed in a spray bottle.
STEP 4
Spray a liberal amount of soapy solution on the adhesive / sticky side of the decal, and on the surface which you are applying the decal.
STEP 7
(Allow the decal to dry for 10 minutes before removing the transfer paper)
Slowly peel and remove the transfer paper. Be careful not to pull the sticker off the surface.
If sticker still sticks on transfer tape, repeat step 6.
STEP 2
Clean the surface thoroughly. Remove any grease, oil or dirt.
STEP 5
Re-position / float the decal on to the surface until desired position
has been achieved.
(Spray more soapy solution if it starts to stick or difficult to re-position)
STEP 8
Check for any lifts, gently rub if down with your fingers if any lifting does occurs.
STEP 3
Peel off the backing paper, ensuring the decal attaches to the transfer paper, nothing should left behind.
STEP 6
Using a squeegee, credit card or similar hard card, squeegee out the soapy solution with firm pressure,
starting from the middle and squeegee outwards. Make sure all soapy solution has been squeegeed out below the decal.
Road Tax Sticker Installation Guide
STEP 1 : Stick your road tax onto the transparant film and trim off the extra
film around your road tax with a pair of scissors.
STEP 2 : Align your road tax and stick it to the empty area of the road tax sticker
(along with the transparent film).
STEP 3 : Stick all 3 layers onto your windscreen.